Skip to main content

Napps Cooling, Heating, and Plumbing

Same-Day Repairs — Flat-Rate Pricing

Plumbing Repair
in Longview, TX

Most plumbing repairs are small, and most of them get expensive only because they were left. A toilet that runs continuously wastes more water in a month than a family uses in a week. A dripping supply valve is a burst pipe with a start date. We fix the everyday failures quickly, at a price agreed before we begin.

  • Faucets, Toilets & Disposals
  • Supply & Shut-Off Valves
  • Main Line Repairs
  • Price Agreed Before Work

Napps Plumbing — Longview & East Texas since 1957

24/7 Emergency Plumbing
Licensed & Insured Texas Plumbers
🏠Family Owned in Longview Since 1957
💳Upfront Flat-Rate Pricing

Everyday Plumbing Repairs

The bread and butter of a plumbing licence. None of these should take long, and none of them should cost more than the number you agreed on the phone.

🚰

Faucets & Fixtures

Dripping spouts, cartridges seized by scale, loose bases and the shut-off valves underneath that no longer shut off. In hard-water country these wear far faster than the manufacturer intended.

  • Kitchen & Bath Faucets
  • Cartridge & Washer Failure
  • Loose or Leaking Bases
  • Angle Stop Replacement
Fixture Installation →
🚽

Toilets

Continuous running, weak or incomplete flush, rocking on the floor, and water appearing around the base — the last of which is a wax ring that has failed and is worth attending to promptly.

  • Running & Phantom Flush
  • Weak Flush
  • Wax Ring & Seal Leaks
  • Fill & Flush Valve Rebuild
Drain Cleaning →
♻️

Garbage Disposals

Humming without turning, jammed impellers, leaks from the housing seam, and units that have simply reached the end of a working life. Replacement is often cheaper than repair on older models.

  • Jams & Reset Faults
  • Leaking Housings
  • Motor Failure
  • Replacement & Fitting
Disposal Installation →
🔩

Valves & Supply Lines

Shut-off valves that seize open, braided supply lines past their service life, and hose bibbs split by a freeze. These are the cheapest repairs on this page and the most expensive to ignore.

  • Seized Shut-Off Valves
  • Braided Supply Line Replacement
  • Split Hose Bibbs
  • Pressure Regulators
Pipe Repair →
🛁

Showers & Tubs

Diverters that will not divert, mixing valves running scalding or cold, and leaks that show up on the ceiling of the room below rather than in the bathroom itself.

  • Shower Valves & Cartridges
  • Diverter Faults
  • Tub Spouts & Drains
  • Leaks Into Ceilings Below
Leak Detection →
🔗

Main Line & Under-Sink Repairs

P-traps, drain assemblies, and repairs to the branch and main lines behind them. If a repair keeps recurring in the same spot, the fault is usually further back than the fitting you can see.

  • P-Traps & Drain Assemblies
  • Branch Line Repairs
  • Recurring Fault Diagnosis
  • Main Line Sections
Sewer & Drain →

When a Repair Stops Being Worth It

We will tell you when a fixture is worth repairing and when you are better off replacing it. Usually the honest answer saves money in the same year.

Faucets: repair unless the body is corroded

A cartridge or washer replacement is inexpensive and buys years on a decent faucet. But if the body itself is pitted, the finish has gone, or you are rebuilding the same fixture for the second time in three years, hard water has effectively ended it and a replacement is the cheaper decision.

Fixture Installation →

Fill valves, flappers and flush assemblies are cheap and fast to rebuild, and most running toilets are fixed for very little. A cracked tank or bowl is not repairable, and a pre-1994 toilet using well over three gallons a flush pays for its own replacement in water within a few years.

Toilet Installation →

A jam or a tripped reset is a five-minute fix and should be priced accordingly. A leaking housing or a dead motor on a unit past about ten years is not economic to repair — the labour to open it up is most of the cost of a new one.

Disposal Replacement →

Angle stops and shut-off valves are among the cheapest components in the house and among the most consequential when they fail. If one weeps, will not close fully, or has visible mineral crust, it gets replaced. Nursing a failing shut-off is how a routine repair becomes a flooded room.

Emergency Plumbing →

Typical Repair vs Replace Guidance

General guidance only — we assess the actual fixture on site.

Fixture Usually Repair Usually Replace
Faucet Cartridge, washer or aerator fault Corroded body, or second rebuild in three years
Toilet Fill valve, flapper, wax ring Cracked tank or bowl, or pre-1994 high-volume
Garbage disposal Jam, reset fault, loose fitting Leaking housing or failed motor past ten years
Shut-off valve Nothing — replace it Any weeping, seizing or crusting
Water heater Element, thermostat, anode rod Tank leaking, or past twelve years

How a Repair Visit Works

Short, predictable, and priced before the toolbag opens.

1
Describe It on the Phone

We ask enough to bring the right parts, so most repairs are finished on the first visit rather than the second.

2
We Confirm the Cause

The visible drip and the actual fault are often different things. We check before quoting rather than after.

3
Flat Price, Then Work

You approve the figure first. If we find something additional we stop and tell you before doing anything about it.

4
Tested and Explained

We run the fixture, confirm the repair holds, and point out anything nearby that is heading the same way.

Small Faults That Get Expensive

Every one of these is cheap this week and considerably less cheap in six months.

💧
A tap that drips overnight A steady drip is thousands of gallons a year, and the same worn seal is usually letting water sit against fittings that then corrode.
🚽
A toilet that refills by itself Phantom flushing means the flapper is passing water continuously. It is one of the largest silent contributors to a high water bill and one of the cheapest repairs.
🟫
A cabinet floor that is soft or stained Water has been sitting under the sink long enough to damage the carcass. The leak is often tiny — the damage is not.
🔩
A shut-off valve that will not turn You will discover this at the worst possible moment. A seized angle stop turns a simple repair into a whole-house shut-off and a flooded room.
🌡️
Hot water that runs out faster than it used to Sediment is occupying the bottom of the tank. Left long enough it takes the elements and then the tank with it.
🎵
Banging pipes when a tap closes Water hammer stresses every joint in the run. It is easily corrected and much less easily undone once a joint has given way.

Why These Fail Here

🪨
Mineral scale from hard water East Texas water leaves deposits that seize cartridges, crust valve seats and coat heater elements, shortening the life of nearly every moving part in the system.
📉
Water pressure set too high Pressure above roughly 80 psi stresses seals, valves and appliance connections continuously. A regulator is inexpensive and prevents a long tail of small failures.
🕰️
Original fixtures in older homes A lot of Longview housing still runs original angle stops and supply lines from the build. Rubber and brass both have a service life and both are well past it.
❄️
Freeze damage nobody noticed A hose bibb or exposed line can split in a freeze and only weep afterwards, which means the damage is discovered months later as a stain rather than a burst.

Why Choose Napps for Plumbing Repairs

Small jobs done properly, by a company that will still be here when the next one comes up.

  • 🚚
    Trucks Stocked for Common Repairs Cartridges, flappers, fill valves, angle stops and supply lines ride with us, so most repairs finish on the first visit.
  • 💵
    Flat Rate, Not an Hourly Meter You approve the price before we start. A repair that turns out fiddly is our problem, not a growing number on your invoice.
  • 🤝
    Honest Repair-or-Replace Advice We will tell you when a fixture is not worth saving, and equally when a replacement you were sold elsewhere is unnecessary.
  • 🏠
    Family Owned Since 1957 Sixty-five years in Longview. The warranty means something because the company is still here to honour it.
Licensed TX Plumbing Contractor TACLA 72668C — HVAC Family Owned Since 1957 ACCA Member 24/7 Emergency Dispatch
65+
Years Serving East TX
24/7
Emergency Availability
★ 4.8
From 229 Google Reviews
2
TX Licences — HVAC & Plumbing
📅 Call 903-758-6482

Or call 903-758-6482 — available 24/7

Real Reviews from Real Napps Customers

4.8 out of 5 · 229 Google reviews

These come straight from our Google Business Profile — unedited, and updated automatically as new reviews come in.

Plumbing Repair Questions

What Longview homeowners ask before booking a repair.

How much does a plumbing repair cost in Longview?

It depends on the fixture and what has actually failed, which is why we quote a flat rate once we have seen it rather than an hourly figure over the phone. What we can promise is that the number you approve is the number on the invoice. Small repairs — a running toilet, a dripping faucet, a jammed disposal — are at the low end and are usually resolved in a single visit.

Usually, yes. Standard repairs are generally same-day or next-day depending on the season and how full the schedule is, and we bring common parts with us so the job finishes on the first visit. Anything actively flooding is treated as an emergency and dispatched immediately, day or night.

Nearly always the flapper has hardened and no longer seals, or the fill valve has stopped shutting off cleanly. Both are inexpensive parts and a quick repair. It is worth doing promptly rather than living with it — a continuously running toilet can add a genuinely surprising amount to a monthly water bill.

Probably. In hard water, a second rebuild inside a few years usually means the valve seat or body is pitted rather than the cartridge being at fault, and you will be back again. At that point a new fixture with a fresh set of internals is the cheaper decision over any reasonable horizon.

Yes. Branch and main line repairs are part of the same licence, and we handle sections that have failed as well as the fittings around them. If a repair keeps recurring in the same area, we look further back along the line rather than replacing the same fitting a third time.

Yes, and it is worth something because we have been at the same address in Longview since 1957. If a repair we made does not hold, call us and we will come back to it. That is a straightforward promise to make when you are not planning to leave town.

Need a Plumbing Repair? Call 903-758-6482.

Flat-rate pricing agreed before work starts, and trucks stocked for the repairs that come up most.

Book a Plumbing Repair in Longview, TX

Describe the fixture and what it is doing and we will come back with a time and a price. Anything actively leaking is better handled by phone.

  • 📞
    24/7 Emergency Line 903-758-6482
  • 📍
    Office Location 1003 West Cotton St., Longview, TX 75604
  • Emergency Service Available 24 hours a day, 7 days a week
  • 💳
    Financing Available Financing available if a repair turns into a larger replacement